ES-FT-BPC-B 16-25 OG

https://www.phoenixcontact.com/us/products/1130816 Connector - ES-FT-BPC-B 16-25 OG - 1130816 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) High-voltage connector for new energy storage system, rated voltage: 1500 V, rated current: 120 A; wiring method: crimping; surface coating: silver; negative pole: black; with one set of plug and socket each; Key Commercial Data Packing unit 1 pc GTIN GTIN 4063151058869 Custom tariff number 85359000 Country of origin China Technical data Ambient conditions Ambient temperature (operation) -40 °C ... 115 °C Ambient temperature (storage/transport) -40 °C ... 70 °C General Nominal voltage UN 1500 V (TUV) Degree of protection IP65 Insulating material PA Contact surface material Ni/Ag Contact material Cu/Cu alloy Seal material Silicon Contact resistance ≤ 5 mΩ Insertion/withdrawal cycles > 100 11/10/2020   Page 1 / 3 https://www.phoenixcontact.com/us/products/1130816 Connector - ES-FT-BPC-B 16-25 OG - 1130816 Technical data General Insertion force ≤ 75 N Withdrawal force ≥ 10 N Current 120 A Behavior in fire Halogen-free yes Standards and Regulations Halogen-free yes Flammability rating according to UL 94 V0 Safety note • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • The products are suitable for applications in plant, controller, and electrical device engineering. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that the protective or functional ground has been properly connected. • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In 11/10/2020   Page 2 / 3 https://www.phoenixcontact.com/us/products/1130816 Connector - ES-FT-BPC-B 16-25 OG - 1130816 Technical data Standards and Regulations this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). • Operate the connector only when it is fully plugged in and interlocked. • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Classifications eCl@ss eCl@ss 9.0 27062002 Accessories Accessories Dust protection cover - ES-FT-BPC PROTECTION CAP - 1130817 Dust protection cap for energy storage connector，color: black RAL9005, ambient temperature for storage and transportation: -40°C ~70°C, operating temperature: -20°C ~105°C, halogen-free, engineering  plastics: UL94 HB, protection class: IP65 (with socket)     Phoenix Contact 2020 © - all rights reserved http://www.phoenixcontact.com 11/10/2020   Page 3 / 3